Issues with D54250WYKH and a Intel 335 240gb ssd. I installed windows 7 64bit from usb without an issue. Then I flashed the Bios, installed the chipset, network, video, audio, usb3 drivers and the SSD toolkit. I then installed all the normal windows 7 updates and after I restart the NUC after the updates I start getting errors.
NUC did not boot. “Windows could not start windows will attempt to repair”. Failed, but a normal boot worked.
Event ID 11 the driver detected a controller error on Device\Ide\IDEport0
I replaced the 335 ssd with a standard hard drive and I don’t get the same issues.
Any Ideas??