Kit purchased new from Amazon. Had been sitting at W7 install from USB stick but no storage.
Obtained new Intel 525 Series SSDMCEAC120B301. Rebooted but W7 did not see drive. BIOS also didn't appear to see the drive but I am new to it and am not sure what it should have shown or if there was a routine that needed to be done to see it.
After a few reboots I removed the card and rebooted. I noticed the card was very hot.
NUC will not boot or POST. Have tried removing all cables, power etc. With power on there is a green LED glow inside the chassis I can see and it is solid.
With network cable plugged in the LED shows activity.
No lights turn on the USB keyboard.
Unit will not power back off through the power button even if held down for more than a minute. AC must be pulled.
Have tried to clear BIOS setup. No help.
Right now all components not included with the kit are removed and it is behaving the same.
Please advise.