I'm attempting to connect this device to an Onkyo TX-NR717 via HDMI. The problem is it always says no signal after a few flickers as it was trying to do something. I believe I have eliminated the receiver as being the issue as everything else I throw at it works just fine even other comptuers but it does leave questions to be answered that the NUC works ok hooked up directly to the TV. I have tried different cables, ports, and a countless other settings even pass-through mode which shouldn't touch anything in theory. To add confusion, in my few hours of messing around with it I was able to get it to work one time and one time only. Not changing any settings, after rebooting the NUC nothing worked again and I was back to square one.
Some things i noticed and other notes:
1) when plugging in the HDMI cable there is a flicker on the screen as if it was trying to connect and failed
2) Receiver shows no signal
3) I do not see any bios post which to me seems that should eliminate all driver issues and point to something in BIOS
4) NUC directly to TV works
5) Receiver is on latest firmware
Thanks in advance