Hi,
I jyst purchased the NUC in the object line, but I can't access the BIOS. I updated (I think, the power light was blinking and I waited 5 mins.) the BIOS to the latest version using the recovery procedure (jumper + usb stick), since I couldn't get any video signal showing up on my TV connected via HDMI cable.
After the update, and after having put the jumper back, I get the message "No boot USB device or something like that which is fine.
I tried to use a Win7 usb-key install, but the installer starts and then crashes due to hardware compatibility (I suspect ACPI related).
So I wanted to tweak some BIOS settings to let windows installer run smoothly but I can't access the BIOS.
If I press f2 at boot the screen just stays black. I read about the 1024x768 requirement but I think that either my TV (Panasonic TH-37PX80E) either my AVR (Yamaha rx-v775) support this resolution.
The keyboard I think it's working since I can start and finish the linux installation process (OpenElec) from a USB key.
Any advice for me?
Thanks,
Gianpaolo