d54250WYK
16 gigs of ram
msata ssd evo 840 500 gb
HDMI cable
Tested on 2 diferent HDMI screens
Samsung SyncMaster SA350
and an asus one (dunno which one is)
Bios version 0035 (if i'm not mistaken)
AntergOS( a arch linux distro/installer)
Here is what happens.
I turn on the NUC screen shows absolutly no image press f2 f10 nothing.
If I wait the regular time it tooks to boot it boots into the system (however it doesn't show the bootloader and it's installed in legacy mode).
I reseated the jumpers to 2-3 and it still showed a black screen and whenever I press f2 or f10 the screen remains black until i power it off or reboot it.
So since it still shows no image when I boot it up and press f2 or f10 and stays there i'm assuming it's something wrong with the bios this has kept on happening in the last 3-10 boots after installing antergOS however this might not be totally related since I also removed the ssd/rams and placed back only one ram and it kept on doing it.
So after searching around high and low and with no results I'd like some feedback on this.