Hi all,
We are working on a project that will be cramming a few nucs (NUC5i7RYH) into a small container. We are just beginning, and I feel we should monitor temperature closely until we are confident that our design will not cause the nucs to overheat. (We will have additional fans! Not just putting them in a box, aka oven! ) Is there any good way to log temp over time? Since I will have several machines going at once, and we plan to use only one monitor, viewing them individually at any given instant in time will be pretty inconvenient. I have very little knowledge in this area, so if you think I might not know something, I probably don't. Thanks for any advice you can give.